GRAPHTEC CE6000 SERIES User Manual page 159

2
Press the POSITION (
to the area to start scanning of the registration mark.
MARK TYPE 1
Point
4
Point 1 (point to make
origin point)
Point
3
Move the tool inside
this area
3
Confirm the position of the tool, and if it is OK, press the
[ENTER] key.
Registration marks are scanned. Following message is displayed when
completed.
4
Press the POSITION (
to the next area to start scanning of the registration mark.
MARK TYPE 1
Point 4
Point 1 (point to make
origin point)
Point 3
Move the tool inside
this area
) key and move the tool carriage
Registration mark scan start area
Point
2
100mm
) key and move the tool carriage
Registration mark scan area
Point 2
Supplement
MARK TYPE 2
Left figure is for 4POINTS. Size and position
of the registration scan start area is same for
2POINTS or 3POINTS.
Point
Point
2
4
Point 1 (point to make
origin point)
Point
3
Move the tool inside
this area
Supplement
Supplement
MARK TYPE 2
Left figure is for 4POINTS. Size and position
of the registration scan start area is same for
2POINTS or 3POINTS.
Point 4 Point 2
Point 1 (point to make
origin point)
Point 3
Move the tool inside
this area
5-42
It will return to ARMS SETTING screen
(1/4) without scanning when you press the
POSITION ( ) key (CANCEL).