About Simple mode
Simple settings can be made from the menu in Simple mode.
Five different tool conditions can be switched on for different media. Copying can also be done from Simple mode.
The green Simple Lamp will come on when Simple mode is activated.
Simple mode and Normal mode are independent from each other. When a different mode is activated, the new
mode's settings will take precedence.
In the default screen, the [SIMPLE] key allows you to change between Simple mode and Normal mode. Switching
will reset the machine (Refer to the next page).
When switching modes, you will start from the media set selection screen.
In Simple mode, RS-232C interface is not available.
In Simple mode, ARMS settings cannot be used. Even in Simple Mode (performing operations) commands for specifying the
registration marks can be used. For items with no specified commands, the specified ARMS settings in Normal mode will be used.
You can choose the following settings on Simple mode's default screen.
See "How to Use Control Panel" for detailed information.
: Set [Tool Conditions]. (See
: Make a copy. (See
You can choose the following settings on the Simple mode menu screen.
: Set Page Length.
: Set HP-GL Initial Point and GP-GL Step Size.
: Set Language and Length Unit.
That concludes the Simple mode menu screen setting explanation.
: Setting Tool Conditions)