GRAPHTEC CE6000 SERIES User Manual page 25

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

3
Attach a media stocker to each of the left and right stand
side bars with two socket head cap screws, using the Allen
wrench. Mount the media stockers so that each one of media
stockers of long side to be rear side.
Media stocker
Stand sides
4
Place the CE6000 onto the stand so that the positioning pins
match up with the holes on the CE6000, and then fasten with
the four coin screws.
Coin screw
5
Tighten the socket head cap screws loosely fastened in Step 2.
Socket head cap screw
Media stocker
Long
Leveler frame
Coin screw
Positioning pin
Please be careful not to get your hands pinched
or stuck when you secure the machine.
Supplement
Check that all of the screws used for
fastening have been tightened. The media
may not be fed correctly if even one of the
screws is loose.
When installing the plotter, make sure that
there are no objects in its vicinity. Leave a
clear space of at least 300 mm around the
plotter.
1-11
CAUTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents