6.2
Manual Position Adjust
Method of manual position adjust is described here.
Supplement
Adjustment will be cleared if following is done after setting the adjustment.
• Set new origin point.
• Set the media again.
• Set rotation or mirror. (Set the rotation or mirror prior to the axis adjustment)
Axis adjustment will convert in accordance with rotation or mirror in this case.
When the inclination of the axis is too large when setting the first and second point, the first and third point, the third and fourth
point, or the second and fourth point, "Angle adjustment error, please reset" will be displayed. After setting the media so as to
make the inclination small, please perform adjustment operations.
Axis adjustment will be cleared when point 1 and point 2 is set to same point.
Operation
1
Load the media with adjustment mark in the plotter.
Loading Media (Paper or Marking Film)
P.2-5
2
Set a cutter plunger or a pen in the tool holder.
3
Press the [PAUSE/MENU] key.
MENU screen is displayed.
4
Press the [2] key (ARMS).
ARMS SETTING screen (1/4) is displayed.
5
Press the [3] key (MARK SCAN MODE).
MARK SCAN MODE screen is displayed.
Supplement
Confirm that the push roller is steadily on the
media within the range of media movement.
This adjustment is based on assumption that
media is slightly tilted. Media might fall off if
the tilting of the media is too large.
Supplement
Perform the settings in Normal mode.
6-3