Change The Cutting Condition (Condition No.); Reset (Revert To The Initial State When The Power Was Turned On.) - GRAPHTEC CE6000 SERIES User Manual

Change the Cutting Condition (Condition No.)

Go through the following steps to change the Cutting Condition (Condition No.):
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
2
Press the [1] key (No.1), the [2] key (No.2), the [3] key (No.3),
the [4] key (No.4), the [ ] key (No.5), the [ ] key (No.6), the
[ ] key (No.7), or the [ ] key (No.8), while simultaneously
pressing the [ENTER] key.
Setting will be set, and it will return to default screen.

Reset (Revert to the initial state when the power was turned on.)

To move to the position as after the power was turned on, do following:
Operation
1
Press the [ENTER] key in READY status.
CONDITION No. selection screen is displayed.
2
Press the [ORIGIN] key (RESET), while simultaneously
pressing the [ENTER] key.
Initialization is performed, and SELECT screen is displayed.
Supplement
Perform the settings in Normal mode.
Supplement
It will return to state when the power is turned
on when the [ORIGIN] key (RESET) is pressed.
Please refer to
the initial state when the power was turned
on.).
Supplement
Perform the settings in Normal mode.
3-6
for Reset (Revert to
P.3-6