Setting And Adjustment Of Arms; Setting Mark Scan Mode And Numbers - GRAPHTEC CE6000 SERIES User Manual

5.2

Setting and Adjustment of ARMS

This section describes the necessary adjustment and settings to correctly scan the registration mark with ARMS.

Setting MARK SCAN Mode and Numbers

P.5-7
Setting Shape (Pattern) of Registration Mark
P.5-11
P.5-12 Setting Registration Mark Size
P.5-14 Setting Mark Distance
Setting Distance Adjustment Between the Registration Mark
P.5-16
Setting Offset Between the Registration Mark and Cutting Origin Points
P.5-18
Adjusting the Sensor Level
P.5-20
Manually Adjusting the Sensor Level (Threshold Value)
P.5-22
Test the Registration Mark Sensor
P.5-24
P.5-25 Setting Speed of the Registration Mark Scan
P.5-27 Adjusting for the Registration Mark Scan Position
Supplement
Turning the Paper-Weight setting off can result in the Registration Mark not being read correctly. For information about the Paper-
Weight setting, please refer to
Setting MARK SCAN Mode and Numbers
Set the MARK SCAN mode to ARMS to perform automatic registration mark scan.
Supplement
There are "AXIS ALIGNMENT" and "OFF" in addition to "ARMS" in the MARK SCAN modes. To turn "OFF", select "OFF" for the
mode in following procedures. See "Manual Position Adjust"
Set the numbers of registration marks when the MARK SCAN mode is set to ARMS. Select the POINTS from
2POINTS, 3POINTS, or 4POINTS. Position of the registration marks for each is as following.
2POINTS
MARK TYPE 1
.
P.7-17
MARK TYPE 2
for AXIS ALIGNMENT".
P.6-1
5-7