Nomenclature; Front View: Ce6000-40 - GRAPHTEC CE6000 SERIES User Manual

1.2

Nomenclature

Front View: CE6000-40

Cutting mat
Cutting groove
Control panel ...........................Used to access various plotter functions.
Push rollers .............................Rollers that push the media against the grit rollers.
Grit rollers ................................Metallic rollers with a file-like surface that feed the media back and forth.
Media sensors .........................The front sensor is used to sense the leading edge of the media. The rear
Tool carriage ............................Moves the cutter-pen or plotting pen across the media during cutting or
Tool holder ...............................Holds the cutter-pen or plotting pen and moves it up or down.
Grit roller position guide ........Stickers on the front of the Y rail and the rear side of the top cover that show
Cutting mat ..............................Cutter blade moved on this mat, preventing wears of the blade.
Cutting groove .........................Use this groove when using the media cutter.
Media set lever ........................Used to raise or lower the Push rollers during the loading or unloading of
USB interface connector ........Used to connect the plotter to the computer with a USB interface cable.
RS-232C interface connector ..Used to connect the plotter to the computer with a RS-232C interface cable.
Grit roller position guide
Push roller
Grit roller
sensor is used to sense the trailing edge of the media.
plotting.
the position of each grit roller. Use these alignment marks as an aid in locating
the Push rollers.
media.
Tool carriage
Control panel
Tool holder
Media set lever
RS-232C interface connector
Media sensor
1-3
USB interface connector