Related to Command Processing
Setting the Command (COMMAND)
There are 2 types of commands, the GP-GL and the HP-GL, that the plotter can use. Match the setting to the
used software, or set it to AUTO.
Automatic detection of the command may make mistake depending on the data. It will give error or malfunction when it has made
mistake. In that case, set the command before using.
Always send the data when the plotter is in READY status when in the automatic detection of the command.
Once the data is cut with the automatic detection of the command, it will be ready to automatically detect next command 10
seconds after completing the cutting. Send next data after 10 seconds has past after previous cutting when sending data with
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
Press the POSITION ( ) key (I/F).
INTERFACE setting screen (1/2) is displayed.
Press the  key (COMMAND).
COMMAND setting screen is displayed.
Select the  key (GP-GL), the  key (HP-GL), or the  key
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACE setting screen (1/2).
Press the [PAUSE/MENU] key.
It will return to the default screen.
Perform the settings in Normal mode.
In simple mode there are no settings. (It's set
to an automatic state.) When a faulty judgment
has been made in Simple mode, please use
Normal mode where commands can be set.