GRAPHTEC CE6000 SERIES User Manual page 148

4
Press the POSITION ( ) key twice.
ARMS SETTING screen (3/4) is displayed.
5
Press the [1] key (SENSOR OFFSET ADJ.).
SENSOR OFFSET ADJ. screen is displayed.
6
Press the [2] key (SCAN).
Following message is displayed.
7
Press the POSITION (
to the area to start scanning of the registration mark.
Registration mark scan area
8
Confirm the position of the tool, and if it is OK, press the
[ENTER] key.
The registration mark for comparison is plotted after scanning the
registration mark (see below). It will return to SENSOR OFFSET ADJ.
screen once the plotting is completed.
Distance
adjustment
value X
Registration mark
for comparison
) key and move the tool carriage
Align the tool to this area
Distance adjustment value Y
Registration mark
for adjustment
Supplement
It will return to ARMS setting screen (3/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
Supplement
It will return to ARMS SETTING screen (3/4)
without plotting when you press the [4] key
(CANCEL).
5-31