Setting The Registration Mark Reading Area - GRAPHTEC FC5100A-75 User Manual

Setting the Reg-
istration Mark
Reading Area
Ad v an ce d F un c ti on s an d S e t ti ng s : A UT O REG . M A R K - Au t o Re gi st r a ti on M ar k S en so r
• Press the ENTER key to store the setting. The display changes to the following
(only displayed if OFF has been selected for DISTANCE ADJUST). The mea-
sured value for the distance between points 1 and 3 is shown on the 3rd row.
Set the actual distance on the 4th row.
Press the RIGHT or LEFT ARROW key to move the cursor. Press the UP or
DOWN arrow key to increase or decrease the number for the distance value.
• Press the ENTER key to store the setting.
• The READY menu appears, and the plotter is ready to start the cutting opera-
tion.
The AUTO REG. MARK sensing function senses the registration mark by moving
the media or the sensor until the plotter locates the registration mark. Normally
there is nothing printed in between the registration marks in order to prevent any
sensing errors, however an image can be printed between the registration marks if
you tell the plotter where to read the registration marks.
You can specify areas that the plotter will not sense by simply specifying the dis-
tance between the registration marks. Once the plotter locates the first registration
mark, it will automatically move the specified distance and begin scanning for the
next mark. You can also use this function to reduce mark-sensing time. Before you
begin, you must know the distance between registration marks. The plotter can
save up to three sets of settings.
• Press the ALIGNMENT key.
• Press the F1 key to select AUTO REG. MARK.
• Press the F1 key to select MARK SCAN MODE.
DISTANCE
POINT 1-3
00303.5
OK?.......... 00303.5
AUTO REG.
MANUAL>*
MARK SCAN
MARK
OTHER SETUPS>*
DISTANCE ADJUST>*
mm.
mm.
MARK>*
SKIP>*
AUTO>*
MODE>*
TYPE>*
103