Moving the Pen While Raised or Lowered in Response to the "W" Command (COMMAND "W")
Here, you can change the settings for the "W" command, which is a GP-GL arc cutting command.
This function set the operation upon receipt of the "W" command for the drawing of arcs.
The pen will move to the specified starting position in the raised status when it is set to TOOL UP, regardless of
the pen's conditions. The pen will move without changing its condition, to the specified starting position in the
lowered status when it is set to TOOL DOWN.
This only has an effect on the cutter tool.
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
Press the POSITION ( ) key (I/F).
INTERFACE setting screen (1/2) is displayed.
Press the POSITION ( ) key.
INTERFACE setting screen (2/2) is displayed.
Press the  key (COMMAND "W").
COMMAND "W" setting screen is displayed.
Press the  key (TOOL DOWN) or the  key (TOOL UP).
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to INTERFACE setting screen (2/2).
Press the [PAUSE/MENU] key.
It will return to the default screen.
Perform the settings in Normal mode.