Confirm The Cutting Data - GRAPHTEC CE6000 SERIES User Manual

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

13.4

Confirm the Cutting Data

Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the transmission
of cutting data is performed correctly.
CAUTION
Do not place your hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage will
start to move immediately after selecting to print the dump list.
Supplement
There may be a difference in the RS-232C transmission condition or the command setting when the printed output and the display
of transmission data does not match. Check the transmission condition and the command.
If the command setting is "Auto", the dump list of the cutting data is not output. Please set the command to "GP-GL" or "HP-GL".
Operation
1
Set a media larger than A4 size.
2
Set the pen tool to the tool holder 1 (Backward) and select
the condition where the pen tool is set.
3
Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4
Press the POSITION ( ) key (TEST).
TEST menu screen (1/2) is displayed.
Supplement
See "Loading Media (Paper or Marking Film)"
P.2-6
Supplement
See "Attaching a Tool"
the pen tool.
For changing the tool conditions please refer
to "Selecting Tool Condition"
for tool settings please refer to "Setting the
Tool"
Supplement
Perform the settings in Normal mode.
13-18
for loading the media.
for setting
P.2-4
P.2-32
.
P.2-38
, and

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents