GRAPHTEC CE6000 SERIES User Manual page 230

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

Symptom
LCD Display
E01019
E01021
E01022
E05001
E05002
E05003
E05004
E05006
E05007
Possible Cause
The plotter is defective.
Load on the motor was too large.
The plotter is defective.
Load on the motor was too large.
The plotter is defective.
There was a heavy load on the up and
down function of the tool carriage.
Data larger than the buffer size cannot be
copied.
There is no data to copy.
Media valid area to copy is too small.
The push roller is not on the grit roller.
Distance between the bottom left and top
right of the AREA setting is less than 10
mm.
Test pattern for the TOOL OFFSET ADJ.
cannot start plotting because the start
position is at the edge of the media.
13-12
Solution
Move the object disturbing the operation,
and turn on the plotter after turning it off
once.
Do not use heavy media.
Move the object disturbing the operation,
and turn on the plotter after turning it off
once.
Do not use heavy media.
Please clear any obstruction in the up and
down function of the tool carriage and turn
the power back on.
If the error display continues to show,
please contact the store where you bought
the product or our Customer Center.
Perform normal cutting not using the copy
mode.
Perform normal cutting by sending the data,
then use the copy mode.
Use larger media.
Confirm the copy start position.
Set the push roller on the grit roller.
Perform the AREA setting again.
Set the start position inside the media.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents