Download Print this page

GRAPHTEC CE6000 SERIES User Manual: Connecting To The Power

Graphtec ce6000 series cutting plotter.
Hide thumbs



Connecting to the Power

Turning on the power of the plotter.
Check that the power switch is turned off. (the " " side is
pressed down)
Connect one end of the provided power cord to the CE6000
AC line inlet and the other end to an electrical socket of the
rated supply voltage.
Turn on the CE6000 by pressing the "|" side of the switch.
LCD on the control panel is lit.
If media has not been loaded, the firmware version number is
displayed, followed by a prompt to load media.
Media set lever raised
(The push roller is up)
Media set lever lowered
(The push roller is down)
When turning the power off, wait over 20
seconds before turning it on again, otherwise
problems may occur with the display.
The Default Screen will appear after
purchasing the machine. See "2.5 About
the Default Screen"
This screen is described as "default screen"
in this document.
Settings such as initial media feed speed and
communication conditions can be performed.
for more


   Also See for GRAPHTEC CE6000 SERIES

   Related Content for GRAPHTEC CE6000 SERIES

Comments to this Manuals

Symbols: 0
Latest comments:
  • Jishad Jan 10, 2018 08:16:
    my graphtec ce 6000-60 showing an error message
    Hardware illegal code. Can you solve this
  • sina oyekunle Dec 21, 2017 02:44:
    my graphtec ce 6000-60 showing an error message: check cam_b-pcb
  • jitendra solanki Jun 14, 2017 05:31:
    i want ce6000 series user manual pdf file