Setting Registration Mark Size - GRAPHTEC CE6000 SERIES User Manual

Graphtec ce6000 series cutting plotter
Hide thumbs Also See for CE6000 SERIES:
Table of Contents

Advertisement

5
Press the [1] key (TYPE1) or the [2] key (TYPE2).
MARK TYPE 1
6
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to ARMS SETTING screen (1/4).
7
Press the [PAUSE/MENU] key.
It will return to the default screen.

Setting Registration Mark Size

The size of registration mark you read out should be preset.
Size of the registration mark that can be set is from 4 mm to 20 mm.
If there is unbalance (skewing) or printing error present in the set media, it will be easier to detect registration
marks with larger sizes. However, if the registration mark is large, then the cutting area will become tighter.
When detecting a registration mark, it will start from the lower left registration mark, and search next in horizontal
and vertical directions. If the print is tilted as shown left, short registration marks will be outside the detection
area.
If the registration marks are large like shown right, it can be detected even if the print is tilted.
It will be easier to detect using larger registration size when using a cutting data long in the media feed direction.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
MARK TYPE 2
5-12
Supplement
MARK TYPEs that the plotter can detect are 2
types shown in bottom left figures.
Supplement
It will return to ARMS SETTING screen (2/4)
without changing the settings when you press
the POSITION ( ) key (CANCEL).
Supplement
Perform the settings in Normal mode.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents