HP XP P9500 Manual page 98

Table 33 Error codes (part code 3005) (continued)
Part Error
Code Number
3005 78060
3005 78061
3005 78062
3005 78063
3005 78064
3005 78065
3005 78067
3005 78075
3005 78076
3005 78077
3005 78078
3005 78107
98 Message (part code group 3nnn)
Error Message
The multi tier pool cannot be disabled
because the RAID level of each tier is
different.
Failed to delete the pool.
Pools cannot be deleted when they are
in the following status:
Deleting a pair of Snapshot is in
progress.
Deleting a volume of Thin
Provisioning is in progress.
Failed to delete the pool.
Pools cannot be deleted when they are
in the following status:
Pairs of Snapshot are remaining.
Volumes of Thin Provisioning are
remaining.
Failed to delete the pool.
Pools cannot be deleted when the pool
volumes of the specified pool is being
formatted.
Failed to delete the pool volume
because the specified pool volume had
one of the following problems.
It is not a pool volume.
The pool volume is not set to the
specified pool.
The LDEV ID of the specified pool
volume is invalid.
The maintenance operation cannot be
performed on the specified THP V-VOLs
because the THP V-VOLs include
blocked pool volumes.
The current microcode version does not
support the specified operation.
The operation cannot be done because
the specified V-VOL is online from an
EAV unsupported OS.
The operation cannot be done because
the specified V-VOL is used for
Compatible XRC.
The operation cannot be done because
the specified V-VOL is used in
Compatible FlashCopy or Compatible
FlashCopy SE.
An internal volume and an external
volume cannot be set as pool VOLs in
the specified pool.
Recommended Action
Check the configuration of the supported
RAID levels, then retry the operation.
Wait until the processing is completed,
then retry the operation.
Delete the following pairs or volumes if
any, then retry the operation.
Snapshot pairs
Thin Provisioning volumes
Retry the operation after the formatting
is completed.
Specify a pool volume, or, specify a pool
volume that is set to the specified pool,
then retry the operation.
Check the LDEV ID of the pool volume,
then retry the operation.
Restore the blocked pool VOLs.
Please contact HP Technical Support.
Set the specified LDEV to OFFLINE.
Release the Compatible XRC setting, and
then retry the operation.
Release the Compatible FlashCopy or
Compatible FlashCopy SE setting, and
then retry the operation.
Verify the pool VOLs to be set in the
specified pool.
Severity
Level
W
W
W
W
W
W
W
E
W
W
W
W