HP XP P9500 Manual page 314

Table 89 Error codes (part code 9605) (continued)
Part Error
Code Number
9605 8120
9605 8122
9605 8123
9605 8124
9605 8125
9605 8126
9605 8128
9605 8132
9605 8134
9605 8135
9605 8136
9605 8138
9605 8139
9605 8141
9605 8142
9605 8150
9605 8151
9605 8152
9605 8153
9605 8154
9605 8155
314 Message (part code group 9nnn)
Error Message
The specified logical volume does not
exist.
This logical volume is busy.
This function is not supported.
This logical volume is a mainframe
volume.
The attribute of the logical volume has
been changed by RAID Manager.
This logical volume is configured as a
command device.
A parameter error occurred.
This error code is not registered.
The attribute of this logical volume
cannot be changed to Read/Write.
This logical volume is already used as
an S-VOL for Remote Copy or Business
Copy.
The command was rejected, because the
licensed capacity was exceeded.
The Reserved setting of the specified
volume cannot be released.
The specified volume is a P-VOL for
Business Copy.
This logical volume cannot be selected
because it is used as a reserve volume
for Auto LUN.
You cannot select this logical volume
because it is used as a Continuous
Access Journal volume.
You tried to set a retention term to a
logical volume whose access attribute is
not Read Only or Protect.
The retention term of the logical volume
cannot be shortened.
You cannot set a retention term to any
mainframe volumes.
The specified retention term exceeds the
maximum.
The retention term of the logical volume
has been changed by RAID Manager.
You cannot change the access attribute
because a retention term is set to the
specified logical volume.
Recommended Action
Specify an open-system volume.
Retry a little later.
Check if the DKCMAIN and SVP
microcode versions are mismatched.
Specify an open-system volume.
Review LDEV information, then retry.
Check the logical volume configuration,
then retry the operation.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
To change the attribute, please contact
HP Technical Support.
Check the logical volume configuration,
then retry the operation.
The currently licensed capacity is
insufficient. To increase the licensed
capacity, buy a new license key.
To release the Reserved setting, please
contact HP Technical Support.
Check the volume, then retry the
operation.
Check the volume, then retry the
operation.
Check the logical volume, then retry the
operation.
Check the logical volume, then retry the
operation.
To shorten it, please contact HP
Technical Support.
Specify an open-systems volume.
Correct the retention term, then retry the
operation.
Check the retention term of the logical
volume, then retry the operation.
To change the access attribute of the
logical volume to Read/Write, please
contact HP Technical Support.
Severity
Level
W
W
E
W
W
W
E
E
E
W
W
E
W
W
W
W
W
W
W
W
W