HP XP P9500 Manual page 168

Hp p9000 remote web console messages (av400-96401, october 2011)
Hide thumbs Also See for XP P9500:
Table of Contents

Advertisement

Table 53 Error codes (part code 6005) (continued)
Part
Error
Code
Number
6005
8924
6005
8926
6005
8927
6005
8929
6005
8930
6005
8931
6005
8932
6005
8934
6005
8936
6005
8939
6005
8940
6005
8943
168 Message (part code group 6nnn)
Error Message
Copy Z T-VOL/reserved volume or a
reserved volume of Auto LUN.
Logical paths exist on the RCU port.
The specified R-VOL is prohibited to use
by Volume Security for Mainframe.
The specified M-VOL is prohibited to
use by Volume Security for Mainframe.
Invalid port type.
Logical paths exist on the RCU port.
Logical paths exist on the RCU port.
Since the configuration definition of the
specified LDKC number or CU number
does not exist, the logical paths
between MCU and RCU cannot be
established.
The Paircreate operation failed because
specified R-VOL is the NAS system
volume.
The Paircreate operation failed. The
version of the specified RCU does not
support Remote Copy with the NAS
volume.
The specified M-VOL cannot be used.
The operation failed because the
specified R-VOL was in a Read Only
status by Volume Retention.
The specified volume or other volume(s)
of the same group in the RCU is being
changed to Simplex/Suspend status.
Retry the operation a few minutes later. volume and other volume(s)
Recommended Action
Delete the LUs defined on
the specified port, then retry
the operation.
Confirm the status of Volume
Security for Mainframe of
the specified R-VOL.
Confirm the status of Volume
Security for Mainframe of
the specified M-VOL.
Refresh the window, then
retry the operation.
If the same problem persists
despite retrying, please
contact HP Technical
Support.
Delete the LUs defined on
the specified port, then retry
the operation.
Delete the LUs defined on
the specified port, then retry
the operation.
Check whether the specified
LDKC number or CU number
is defined as configuration
information of the MCU.
Check the configuration of
the specified R-VOL.
Check the microcode version
of the RCU.
Check the LUN of the
specified M-VOL by using
RAID Manager, and specify
the LUN with the value less
than 1,024 for the M-VOL.
Confirm the status of the
specified R-VOL.
Refresh the window a few
minutes later, and check the
status of the specified
of the same group in the
RCU. If it is possible to
perform operations on the
volume(s), retry the
operation.
Severity Level
W
W
W
W
W
W
W
W
W
W
W
W

Advertisement

Table of Contents
loading

This manual is also suitable for:

P9000P9500

Table of Contents