HP XP P9500 Manual page 266

Table 65 Error codes (part code 7105) (continued)
Part Error
Code Number
7105 8549
7105 8550
7105 8551
7105 8552
7105 8553
7105 8554
7105 8555
7105 8556
7105 8557
7105 8558
7105 8559
7105 8560
7105 8561
7105 8562
7105 8563
7105 8564
7105 8565
7105 8566
7105 8567
7105 8568
266 Message (part code group 7nnn)
Error Message
The S-VOL is not implemented.
The command has been rejected,
because the specified S-VOL is blocked
or used as a system disk.
The S-VOL is being formatted.
This volume cannot be specified as an
S-VOL because it is used as a command
device.
The T-VOL is not implemented.
The command has been rejected,
because the specified T-VOL is blocked
or used as a system disk.
The T-VOL is being formatted.
This volume cannot be specified as an
T-VOL because it is used as a command
device.
The volume is not implemented.
The command has been rejected,
because the specified volume is blocked
or used as a system disk.
The volume is being formatted.
This volume cannot be specified because
it is used as a command device.
The command code is invalid.
The command code sender is invalid.
The volume type is invalid.
The volume type is invalid.
The command code sender is invalid.
The attribute of the reserved volume is
invalid.
The number of effective lists is invalid.
The emulation type is invalid.
Recommended Action
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as an S-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
As the S-VOL, specify a volume that is
not used as a command device.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as a T-VOL. Specify another volume.
Wait until the volume is formatted, and
retry the operation.
Release the command device, then retry
the operation.
You cannot execute the operation for the
volume which is not implemented.
Restore the blocked volume, then retry
the operation.
The system disk cannot be specified
as a reserved volume. Specify another
volume.
Wait until the volume is formatted, and
retry the operation.
Specify a volume that is not used as a
command device.
Please contact HP Technical Support.
If this problem persists please contact HP
Technical Support.
Please contact HP Technical Support.
Please contact HP Technical Support.
Check the contents, and retry.
Check the contents, and retry.
Please contact HP Technical Support.
Specify the volume of the supported
emulation type.
Severity
Level
W
E
W
W
W
W
W
W
W
W
W
W
E
E
W
W
E
E
E
W