HP XP P9500 Manual page 188

Hp p9000 remote web console messages (av400-96401, october 2011)
Hide thumbs Also See for XP P9500:
Table of Contents

Advertisement

Table 56 Error codes (part code 6505) (continued)
Part
Error
Code
Number
6505
7060
6505
71 1 1
6505
7310
6505
8000
6505
8001
6505
8002
6505
8100
6505
8102
6505
8700
6505
8701
6505
8702
6505
8703
6505
8704
6505
8705
6505
8706
188 Message (part code group 6nnn)
Error Message
An error occurred during SVP
processing.
An error occurred during SVP
processing.
This error code is not registered.
An error occurred during SVP
processing.
A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
An error occurred during SVP
processing.
This function is not supported.
Please retry operation.
The logical path between the local and
the remote subsystems is invalid.
The status of the primary data volume is
not valid.
The specified number of paths is less
than the minimum number of paths in the
DKC Option window.
The specified number of paths is less
than the minimum number of paths in the
DKC Option window, due to a
communication error between the local
and the remote storage systems.
The operation failed due to one of the
following reasons.
The secondary data volume was
blocked.
The restore journal was not
registered.
The journal volumes of the restore
journal were blocked.
The path could not be deleted due to a
communication error between the local
and the remote subsystems.
Parameter specified by Remote Copy
operation is invalid.
Recommended Action
If the same error occurs despite retrying,
please contact HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
If the same error occurs despite retrying,
please contact HP Technical Support.
Retry the operation. If this problem
persists, please contact HP Technical
Support.
Wait a while, then retry the operation.
Wait a while, then retry the operation.
Retry the operation. If this problem
persists, please contact HP Technical
Support.
Check whether the DKCMAIN microcode
version and the SVP microcode version
are mismatched.
Retry the operation.
Check the path status and edit the path
again.
Refresh and check the window. If
possible, retry the operation on the
primary data volume.
Check the number of paths.
Verify that the secondary data volume is
not blocked, the restore journal is
registered, or the journal volumes of the
restore journal are not blocked.
Check the CHA status on the window. If
the CHA is blocked, replace the CHA,
then retry the operation.
Enter the correct data.
Severity
Level
E
E
E
E
W
W
E
E
W
W
W
W
W
E
W

Advertisement

Table of Contents
loading

This manual is also suitable for:

P9000P9500

Table of Contents