HP XP P9500 Manual page 291

Table 68 Error codes (part code 8105) (continued)
Part Error Error Message
Code Number
8105 5744 The command device security switch
cannot be turned on because this is not
command device.
8105 5745 The security switch on the port is off. Turn
on the switch.
8105 5746 The group ID is invalid.
8105 5747 The group cannot be added. Change
the name of the group.
8105 5748 The group ID does not exist.
8105 5749 The same group ID is already registered.
8105 5750 The same group name is already
registered.
8105 5751 The group ID does not exist.
8105 5752 The group name does not exist.
8105 5753 There is a difference between the current
port ID/group ID and the specified one.
8105 5754 The intermediate volume cannot be
specified as a command device.
8105 5755 The security switch on the port remains
off. Turn the switch on.
8105 5756 The number of WWN cannot exceed
255 per port.
8105 5757 The same WWN is already registered.
8105 5758 No name can be added to the group ID
(00).
8105 5759 The same name is already registered.
8105 5761 The WWN does not exist.
8105 5762 The name does not exist.
8105 5764 The number of LUN cannot exceed 512
per port or 256 per host group.
8105 5765 The LUN is already used.
8105 5766 The specified CU:LDEV is invalid.
8105 5767 The LUN does not exist.
8105 5768 There is a difference between the current
LUN and the specified LUN.
8105 5769 The group cannot be added.
8105 5770 The port cannot be changed because the
port is an initiator port.
8105 5771 The setting cannot be performed,
because an invalid PCB mode is set to
the specified CHA.
8105 5785 The system LU cannot be used.
Recommended Action
Turn on the command device switch.
Turn on the security switch on this port.
Correct the group ID.
Correct the name of the group.
Correct the group ID.
Correct the group ID.
Correct the group name.
Correct the group ID.
Correct the group name.
Correct the port ID and the group ID.
Correct the CU and LDEV.
Turn on the security switch on this port.
Add the WWN to another port.
Correct the WWN.
Correct the group ID.
Correct the name.
Correct the WWN.
Correct the name.
Add the LUN to another group or
another port.
Correct the LUN.
Correct the CU and LDEV.
Correct the LUN.
Correct the LUN.
Correct the group ID.
Set the port attribute to target in
advance.
The PCB mode value is invalid. Specify
a correct value.
Correct the CU and LDEV.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 8105 291