HP XP P9500 Manual page 199

Table 56 Error codes (part code 6505) (continued)
Part Error Error Message
Code Number
6505 58093 The specified primary data volume is
already registered in another journal.
6505 58094 The specified primary data volume
cannot be deleted because the volume
is already registered in another journal.
6505 58096 The specified volume is a reserve volume
of a mainframe host.
6505 58097 Continuous Access Journal or Continuous
Access Journal Z is not installed in the
primary storage system.
6505 58098 The cache or the shared memory is in
an abnormal state.
6505 58099 The cache or the shared memory is in
an abnormal state.
6505 58100 The serial number or the controller ID of
the remote subsystem is incorrect.
6505 58101 The pair status is incorrect.
6505 58102 An internal error occurred.
6505 58103 The specified secondary data volume is
a reserve volume of a mainframe host.
6505 58104 The specified secondary data volume is
already used by Compatible XRC.
6505 58105 Continuous Access Journal or Continuous
Access Journal Z is not installed in the
remote storage system.
Recommended Action
Identify the journal where the specified
primary data volume is registered.
Identify the journal where the specified
primary data volume is registered.
Check the status of the specified volume
from the mainframe host.
Install Continuous Access Journal or
Continuous Access Journal Z in the
primary storage system, then retry the
operation.
Please contact HP Technical Support.
Please contact HP Technical Support.
Check the serial number and the
controller ID of this remote storage
system and already registered remote
storage systems, then specify the correct
values.
If the specified values are correct, check
the cable connection of the remote
storage system. If the problem persists,
please contact HP Technical Support.
Refresh the window, and check the pair
status.
The pair status may be different in the
primary storage and the secondary
storage system. Wait for a while, then
retry the operation. Contact HP Technical
Support when the pair status of the pair
does not match between the primary and
the secondary storage system.
In the volume attached to Fujitsu OS, the
pair cannot be created by specifying
System for Timer Type.
Specify Local for Timer Type, then retry
the operation.
Check the status of the specified
secondary data volume from the
mainframe host.
Check the status of the specified
secondary data volume from the
mainframe host.
Continuous Access Journal or Continuous
Access Journal Z must be installed in
both the local and remote storage
systems when you create paths or pairs
with Continuous Access Journal or
Continuous Access Journal Z. Install
Continuous Access Journal or Continuous
Severity
Level
W
W
W
W
E
E
W
W
E
W
W
W
Part code 6505 199