HP XP P9500 Manual page 298

Table 74 Error codes (part code 8505) (continued)
Part Error
Code Number
8505 58313
8505 58315
8505 58316
8505 58317
8505 58318
8505 58339
8505 65740
8505 75013
8505 75015
8505 75026
298 Message (part code group 8nnn)
Error Message
intended CLPR is too high. Please wait
until the write pending rate falls, and
then retry the operation.
The configuration cannot be changed
because the available Cache Residency
size or the number of Cache Residency
areas in the intended CLPR is insufficient.
A maintenance job is running in the disk
subsystem (Correction Copy, Drive Copy,
LDEV formatting, LDEV shredding, and
Extent shredding). Retry the operation
after the maintenance job is completed.
Parity groups in CLPR are being migrated
in the disk subsystem. Please wait for a
while, and then retry the operation.
CLPR capacity is being changed in the
disk subsystem. Please wait for a while,
and then retry the operation.
An error occurred on the DKC while
obtaining information about the progress
of CLPR procesing.
The CLPR which the parity groups belong
to cannot be changed, because the
specified parity groups do not include
all the journal volumes in a journal of
Continuous Access Journal and
Continuous Access Journal Z. Make sure
to specify the parity groups that contain
all the journal volumes in the journal.
The configuration changing processes
are conflicting at DKC.
The cache capacity of CLPR cannot be
decreased because Cache Residency is
set to the CLPR.
The specified LDEV cannot be used
because the user has no access right to
a resource group to which the LDEV
belongs.
The specified parity group cannot be
used because the user has no access
right to a resource group to which the
parity group belongs.
Recommended Action
Check the Cache Residency size and the
number of Cache Residency areas.
Retry the operation after the maintenance
job is completed.
If LDEV formatting, LDEV shredding or
Extent shredding is not operating, please
contact HP Technical Support.
Wait a while, then retry the operation.
Wait a while, then retry the operation.
If this problem persists, please contact
HP Technical Support.
Specify the parity groups that do not
contain any journal volumes of
Continuous Access Journal and
Continuous Access Journal Z, or specify
the parity groups that contain all the
journal volumes in the journal.
Check if the configuration changing
process by RAID Manager, Auto LUN,
or Quick Restore is not in the operation,
then retry the operation.
Decrease the cache capacity of CLPR
after releasing the Cache Residency
setting.
Verify the resources allocation for the
user with security administrator role.
Verify the resources allocation for the
user with security administrator role.
Severity
Level
W
W
W
W
E
W
W
W
W
W