HP XP P9500 Manual page 315

Hp p9000 remote web console messages (av400-96401, october 2011)
Hide thumbs Also See for XP P9500:
Table of Contents

Advertisement

Table 89 Error codes (part code 9605) (continued)
Part
Error
Error Message
Code
Number
9605
8156
You cannot change the access attribute
because the expiration lock is set to
Enable.
9605
58404
The specified operation cannot be
executed because the LDEV shredding
or the LDEV format is being executed.
9605
58412
The attribute of the pool volume cannot
be changed.
9605
58413
The attribute of the virtual volume of the
Snapshot cannot be changed.
9605
58414
The attribute of the P-VOL or the S-VOL
of the Snapshot cannot be changed.
9605
58418
The access attribute cannot be changed,
because the status of the specified
Continuous Access Journal volume is in
"PAIR" or in "COPY."
9605
58422
An error occurred during SVP
processing.
9605
58423
An error occurred during SVP
processing.
9605
58424
The specified logical volume is blocked.
9605
58429
A retention term is set to the specified
logical volume.
9605
58434
This logical volume is busy.
9605
58435
This logical volume is busy.
9605
58436
The access attribute of the logical volume
has already been changed.
9605
58438
This logical volume is configured as a
command device.
9605
58442
The emulation type of the logical volume
is not OPEN-V.
9605
58448
The specified logical volume is blocked,
or the LDEV is being formatted or
shredded.
9605
58450
An error occurred during SVP
processing.
Recommended Action
Set the expiration lock to Disable, then
change the access attribute.
Retry the operation after the process is
completed.
Select another volume.
Select another volume.
Select another volume.
Release or suspend the Continuous
Access Journal volume.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Restore the logical volume.
Make the setting to another logical
volume.
Retry a little later.
Retry a little later.
See the Data Retention window and
check the following about the logical
volume you have selected:
The access attribute must be
Read/Write
The logical volume must be able to
be specified as an S-VOL
You must be able to set a path to the
logical volume using the RAID
Manager or Remote Web Console
No mode is set using the RAID
Manager
Check the logical volume configuration,
then retry the operation.
Select a logical volume whose emulation
type is OPEN-V.
Retry the operation after the logical
volume has recovered from the blocked
status or after the LDEV has been
formatted or shredded.
If this problem persists, please contact
HP Technical Support.
Severity
Level
W
W
W
W
W
W
E
E
E
W
W
W
W
W
W
W
E
Part code 9605
315

Advertisement

Table of Contents
loading

This manual is also suitable for:

P9000P9500

Table of Contents