HP XP P9500 Manual page 267

Table 65 Error codes (part code 7105) (continued)
Part Error Error Message
Code Number
7105 8569 The command has been rejected,
because the area of the differential table
or pair table to set pairs is insufficient.
7105 8570 The selected volume does not exist.
7105 8571 The volume is already defined as a
reserved volume.
7105 8572 The volume is already defined as S-VOL.
7105 8573 The volume is defined as a source
volume for Auto LUN.
7105 8574 The volume is defined as a target volume
for Auto LUN.
7105 8575 The selected volume is not a reserved
volume.
7105 8576 No reserved volume is available for use.
7105 8577 The number of reserved volumes to be
defined exceeds the maximum.
7105 8578 The S-VOL is already paired with a
backup volume. Therefore, it cannot be
paired with the target volume.
7105 8579 No volume is defined as a reserved
volume.
7105 8580 The specified volume is for backup
servers only.
7105 8581 The specified volume is not for backup
servers only.
7105 8582 The emulation type of the target volume
is being changed.
7105 8583 The RAID level of the specified volume
is not supported.
7105 8584 No volume is defined as a reserved
volume.
7105 8585 The number of reserved volumes exceeds
the maximum.
7105 8586 The number of groups that can be set in
the same subsystem is invalid.
7105 8587 The number of pairs that can be set in
the same group is invalid.
7105 8588 The specified group number is not set.
7105 8589 The specified group name is invalid.
7105 8590 The group name and the number do not
match.
Recommended Action
See the section "Planning number of
pairs" in the HP P9000 Business Copy
for Mainframe Systems User Guide for
the relation between the number of pairs
that can be created and the shared
memories.
Refresh the window, and retry the
operation.
Check the contents, and retry.
Check the contents, and retry.
Release the Auto LUN setting.
Release the Auto LUN setting.
Check the status of the volume.
Check the contents, and retry.
Stop the operation of the Reserve volume
setting, or delete the Reserve volume.
Check the contents, then retry the
operation.
Define the reserve volume, then retry the
operation.
You cannot use the volume. Specify other
volume, and retry the operation.
Check the contents, and retry.
Wait a while, and retry the operation.
Specify the volume of the supported RAID
level.
Define the reserve volume, then retry the
operation.
Stop the operation of the Reserve volume
setting, or delete the Reserve volume.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Check the contents, and retry.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
W
Part code 7105 267