HP XP P9500 Manual page 286

Table 68 Error codes (part code 8105) (continued)
Part Error
Code Number
8105 1 128
8105 1 130
8105 1 131
8105 1 132
8105 1 133
8105 1 134
8105 1 135
8105 1 138
8105 1 140
8105 1 170
8105 1 181
8105 1 193
8105 1350
8105 1352
286 Message (part code group 8nnn)
Error Message
An error occurred. If this problem
persists, please contact HP Technical
Support.
The specified name is the same as the
system default name. Please change the
name.
Failed to set the host group because the
number of host groups exceeds the
maximum that can be set in a port.
Failed to set the WWN because the
number of WWNs exceeds the
maximum that can be set in a port.
Failed to set the host mode because the
number of host modes exceeds the
maximum that can be set in a port.
Failed to set the path because the
number of paths exceeds the maximum
that can be set in a port.
When setting the port information (Fibre
Address/Fibre Topology/Channel
Speed), multiple change instructions are
set to the same port.
The same setting is specified at LUNM
operation
Because the Port Group setting is done,
it is impossible to change.
The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
The specified path cannot be added,
because the volume is used by a Remote
Copy pair.
You cannot add paths to Remote Copy
or Business Copy pair volumes.
Add path to the initiator port failed.
Logical paths remain on the Fibre-MCU
port. This operation may cause a fatal
damage to the logical paths. Please stop
this operation. If you want to continue
this operation, please remove the logical
paths from the MCU port first.
Recommended Action
Check the setting(s), then retry the
operation.
Correct the specified contents, and
request again.
The configuration information has been
already changed.
Check the settings, and request the
setting of the configuration information
again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Check the setting(s), then retry the
operation.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again
Release the Port Group setting.
Connect settings, then retry.
Correct the specified contents, and
request again.
Correct the settings, then retry.
The port you are trying to set is for
Remote Copy. You must change the
attribute (Target or RCU Target) when
adding a path.
Since the port you are trying to set is for
Remote Copy, you must delete the logical
path, then retry the port setting.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W
W