HP XP P9500 Manual page 91

Table 33 Error codes (part code 3005) (continued)
Part Error Error Message
Code Number
maintained is in PSUS status or being
restored.
3005 58626 A Snapshot pair is defined.
3005 58706 An error occurred during SVP
processing.
3005 65650 The specified volume is used as a
System Disk volume.
3005 65659 The specified volume is used as a Thin
Provisioning volume.
3005 65671 The pool volumes associated with the
Thin Provisioning volume is included in
the items to be maintained.
3005 65675 The LDEV to be operated is not included
in the specified parity group.
3005 65676 The association cannot be made
because the pool is in a different CLPR.
3005 65688 A failure occurred while formatting.
3005 65689 A failure occurred while quick
formatting.
3005 65690 The specified volumes contain volumes
that are being quick formatted.
3005 65691 Preparing for quick format.
3005 65692 The specified volumes contain volumes
that quick format cannot be executed.
3005 65693 Quick Format cannot be executed.
There is no System Disk area for Quick
Format, the capacity of the System Disk
is insufficient, or the System Disk is
blocked.
3005 65694 Quick format cannot be executed
because the number of parity groups
being quick formatted has exceeded
the maximum.
3005 65695 An error occurred during SVP
processing.
3005 65717 The specified volumes contain volumes
that cannot be formatted.
3005 65740 The configuration changing processes
are conflicting at DKC.
Recommended Action
Cancel the pair definition, then retry the
operation.
If this problem persists, please contact
HP Technical Support.
Check the setting of the specified volume.
Check the setting of the specified volume.
Release the association between the pool
volume and the Thin Provisioning volume.
Check the setting and status of the LDEV
in the specified parity group.
Confirm that it is associated with a pool
in the same CLPR.
Cancel the format processing from the
SVP, then retry the formatting processing
again.
Cancel the quick formatting processing
from the SVP, then execute the quick
formatting processing again.
Check the settings and retry the
operation.
Check the status and wait until the status
changes to a status that maintenance is
possible.
Select only the volumes that quick format
can be executed and execute quick
format.
Add the System Disk, or restore the
blocked System Disk then retry Quick
Format.
If this problem persists even though the
system disk is normal and has enough
capacity, please contact HP Technical
Support.
Change the setting or execute the quick
formatting process after the quick format
processing for other parity groups has
completed.
If this problem persists, please contact
HP Technical Support.
Select only the volumes that can be
formatted and format the volumes.
Check if the configuration changing
process by RAID Manager, Auto LUN,
Severity
Level
W
E
W
W
W
W
W
W
W
W
W
W
W
W
E
W
W
Part code 3005 91