HP XP P9500 Manual page 230

Hp p9000 remote web console messages (av400-96401, october 2011)
Hide thumbs Also See for XP P9500:
Table of Contents

Advertisement

Table 58 Error codes (part code 6510) (continued)
Part
Error
Code
Number
6510
59008
6510
59009
6510
59010
6510
5901 1
6510
59013
6510
59026
6510
59030
6510
59031
6510
59039
6510
59042
6510
59043
6510
59100
230 Message (part code group 6nnn)
Error Message
Are you sure you want to delete the
paths of the specified subsystem?
Since the number of preview data
exceeded the maximum, the excess data
were discarded. No more preview data
can be stored.
WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
primary data volume and the secondary
data volume of the pair are already
synchronized?
Are you sure you want to output the %s
file?
The specified file already exists. Do you
want to overwrite this file?
The same DKC is specified more than
once.
The monitoring data saved at present
will be deleted.
The monitoring data being saved at
present is deleted when the monitoring
switch is set to Enable at the next time.
You cannot add journal volumes because
Continuous Access Journal is not
installed.
There are no valid journals.
The number of journal volumes in some
journals exceeds the maximum.
Adjust the number of journal volumes.
The same volume is stored more than
once in the Preview list.
Please use the sort function to identify
volumes with the same LDKC number,
the same CU number and the same LDEV
number.
Recommended Action
To delete the specified path, click [OK].
Otherwise, click [Cancel].
Click [OK]. Apply the preview data to
the storage system, then retry the
operation.
Check the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
To output the file, click [Yes]. Otherwise,
click [No].
To overwrite the file, click [Yes].
Otherwise, click [No].
Check the parameters of the DKC setting.
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
To continue processing, click [OK]. To
stop processing, click [Cancel].
If the currently monitoring data is
needed, use the Export Tool to save the
data.
Purchase a license for Continuous Access
Journal, then install it.
All journals are used by Continuous
Access Journal Z or Continuous Access
Journal. If possible, delete the journals
for Continuous Access Journal Z or
Continuous Access Journal, then start the
Continuous Access Journal Z window or
the Continuous Access Journal window.
Reduce the number of journal volumes
to be registered, or increase the number
of journal volumes to be deleted.
Use the sort function to identify volumes
with the same LDKC number, the same
CU number and the same LDEV number.
Severity
Level
W
W
i
i
W
W
W
i
W
W
W
W

Advertisement

Table of Contents
loading

This manual is also suitable for:

P9000P9500

Table of Contents