HP XP P9500 Manual Page 300

Hp p9000 remote web console messages (av400-96401, october 2011).
Hide thumbs

Advertisement

Table 76 Error codes (part code 8510) (continued)
Part
Error
Code
Number
8510
55262
8510
55636
8510
57001
8510
59067
8510
59101
8510
59102
8510
591 10
8510
591 14
8510
79000
8510
79001
8510
79002
300 Message (part code group 8nnn)
Error Message
The Parity Group cannot be migrated to
the CLPR that you newly created. Please
apply the tentative settings with no parity
groups to the CLPR that you have
created, and then migrate the parity
group.
The CLPR that has some parity groups
cannot be deleted. Migrate all parity
groups in the CLPR to another CLPR, and
then delete the CLPR.
The partition configuration may contain
some inconsistent information.
The maximum number of SSIDs that can
be registered will be registered except
the duplicate SSIDs.
The SSID(s) are associated with the
specified CU. All SSIDs that are
associated with the CU are to be added
to this SLPR.
The SSID(s) are associated with the
specified CU. All SSIDs that are
associated with the CU are to be deleted
from this SLPR.
SSIDs that are associated with the
selected CU cannot be added to this
SLPR because too many SSIDs have been
set in the SLPR.
Ports in high-speed mode are set across
multiple SLPRs. If you perform this
operation, the user having access to
these SLPRs will become unable to use.
Do you want to continue this operation?
Notice from Partition Definition:
Installation of Open System Array
Management is required to create more
than four CLPRs.
Notice from Partition Definition:
Additional cache memory is required for
CLPR0 to create a CLPR.
Notice from Partition Definition:
CLPR cannot be made any more.
Recommended Action
Apply the tentative settings with no parity
groups to the CLPR that you have
created, then migrate the parity group.
Migrate all parity groups in the CLPR to
another CLPR, then delete the CLPR.
If you clicked [Yes], set the changes
again.
If you clicked [No], retry the operation.
If this problem persists, please contact
the system manager.
To initialize the partition configuration,
click [Yes]. To stop the operation, click
[No].
Check the settings.
Check the settings.
Check the settings.
Delete unnecessary SSIDs from this SLPR,
and then retry the operation.
Check the settings.
Click [OK].
Click [OK].
Click [OK].
Severity
Level
W
W
E
W
i
i
W
E
i
i
i

Advertisement

   Also See for HP XP P9500

   Related Manuals for HP XP P9500

Comments to this Manuals

Symbols: 0
Latest comments: