Part Code 8105 - HP XP P9500 Manual

Table 67 Error codes (part code 8005) (continued)
Part Error
Code Number
8005 65783
8005 68761
8005 68762
8005 68766
8005 68785
8005 68786

Part code 8105

Table 68 Error codes (part code 8105)
Part Error
Code Number
8105 1002
8105 1003
8105 1004
8105 1005
8105 1007
Error Message
There are functions that cannot change
the system disk option due to one of the
following reasons:
The system disk capacity is
insufficient.
The system disk is blocked.
An error occurred on the DKC side.
This functionality is not available.
Encryption License Key is required.
The serial number of the encryption key
does not match.
The specified parity group is not
mounted.
The specified parity group is not
blocked.
Error Message
The specified volume cannot be set as a
command device or a component of a
LUSE volume, because it is being used
as the volume of Remote Copy, Business
Copy, Auto LUN, or Snapshot.
You are trying to set multiple paths to the
same volume from one group.
Multiple volumes are specified to a single
port, group or LUN combination.
The following volumes cannot be
specified when you change the path
configurations:
Volumes that do not exist
Volumes other than the top LUs in
expanded LUs
Volumes reserved by Auto LUN
System Disk volume
Failed to remove the path. The specified
path is the last path of the volumes used
Recommended Action
Confirm the setting status of the current
system disk option. For the functions that
could not be set, add a system disk or
restore the blocked system disk, then
retry the operation.
If this problem persists, please contact
HP Technical Support.
Install the required program product.
Use the correct encryption key.
Check the specified parity group.
Check the status of the specified parity
group.
Recommended Action
Select another volume.
The configuration information has been
already changed.
Check the settings, and request the
setting of the configuration information
again.
The configuration information has been
already changed.
Check the settings, and request the
setting of the configuration information
again.
Check the settings, then retry the
operation.
Check the setting.
Severity
Level
E
E
W
W
W
W
Severity
Level
W
W
W
W
W
Part code 8105 283