HP XP P9500 Manual page 109

Table 38 Error codes (part code 3205) (continued)
Part Error Error Message
Code Number
3205 5013 An error occurred during SVP
processing.
3205 5099 An error occurred during SVP
processing.
3205 551 1 A necessary program product is not
installed.
3205 5827 An error occurred during SVP
processing.
3205 5828 An error occurred during SVP
processing.
3205 6012 An error occurred during SVP
processing.
3205 6022 An error occurred during SVP
processing.
3205 6533 An error occurred during SVP
processing.
3205 6534 The number of V-VOLs that can be
registered in the storage system has
reached the maximum.
3205 6535 The configuration cannot be changed
because the LUN Path is remained in the
target volume.
3205 6536 The target volume cannot be changed
due to its LUSE configuration.
3205 6537 The setting process has not been
executed because there is no error in this
setting, but an error in the others settings.
3205 8000 An error occurred during SVP
processing.
3205 8001 An error occurred during SVP
processing.
3205 8102 This function is not supported.
3205 8140 The configuration of Compatible
FlashCopy or Compatible FlashCopy SE
is defined.
3205 8958 An error occurred on the DKC side.
3205 8966 An error occurred on the DKC side.
3205 56513 An emulation type that cannot be added
is specified.
Recommended Action
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Install the necessary program product(s).
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Reduce the number of V-VOLs registered
in the storage system, then retry the
configuration operation.
Release the LUN Path, then change the
configuration again.
Release the LUSE volume, then change
the configuration again.
Check the error factor in the others
settings.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Check whether the DKCMAIN microcode
version and the SVP microcode version
are mismatched.
Release the configuration definition of
Compatible FlashCopy or Compatible
FlashCopy SE, and then retry the
operation.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Check the emulation type. If you want to
change the cache segment size to set the
specified emulation type, please contact
HP Technical Support.
Severity
Level
E
E
W
E
E
E
E
E
W
W
W
W
E
E
W
W
E
E
W
Part code 3205 109