Table 88 Error codes (part code 9210) (continued)
Part
Error
Code
Number
9210
81 12
9210
9107
Part code 9605
Table 89 Error codes (part code 9605)
Part
Error
Code
Number
9605
5013
9605
5030
9605
5041
9605
551 1
9605
5809
9605
6012
9605
6023
9605
6038
9605
6502
9605
6533
9605
6537
9605
7060
9605
71 1 1
9605
7310
9605
8001
9605
8002
9605
8102
Error Message
There is no valid volume.
The value that is under setup is not
reflected yet. Do you want to continue
the operation?
Error Message
An error occurred during SVP
processing.
No commands are issued.
The number of issued commands exceeds
the maximum.
The program product is not installed.
The number of requests for combining
LUs does not match the number of the
LUs.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
The mistake is found in the set
parameter.
Processing in progress. Please wait for
a while, and then retry the operation.
An error occurred during SVP
processing.
The setting process has not been
executed because there is no error in this
setting, but an error in the other settings.
An error occurred during SVP
processing.
An error occurred during SVP
processing.
This error code is not registered.
An error occurred while connecting to
the subsystem. Please retry a little later.
A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
This function is not supported.
Recommended Action
Mount volumes, then retry the operation.
To continue processing, click [OK]. To
stop processing, click [Cancel].
Recommended Action
If this problem persists, please contact
HP Technical Support.
Issue a command again.
Decrease the number of commands.
Install Program Product.
Review LUs, and retry the operation.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Wait a few minutes, then retry the
operation.
If this problem persists, please contact
HP Technical Support.
Check the error factor in the other
settings.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Retry a little later.
Retry a little later.
Check if the DKCMAIN and SVP
microcode versions are mismatched.
Severity
Level
W
W
Severity
Level
E
W
W
W
W
E
E
E
W
E
W
E
E
E
W
W
E
Part code 9605
313