HP XP P9500 Manual page 49

Table 22 Error codes (part code 0605) (continued)
Part Error Error Message
Code Number
0605 2522 The volume is reserved by Auto LUN.
0605 3003 An error occurred during SVP
processing.
0605 5013 An error occurred during SVP
processing.
0605 5099 An error occurred during SVP
processing.
0605 551 1 A necessary program product is not
installed.
0605 5827 An error occurred during SVP
processing.
0605 5828 An error occurred during SVP
processing.
0605 6012 An error occurred during SVP
processing.
0605 6022 An error occurred during SVP
processing.
0605 6533 An error occurred during SVP
processing.
0605 6534 The number of external volumes that can
be registered in the storage system has
reached the maximum.
0605 6535 The configuration cannot be changed
because the LUN Path is remained in the
target volume.
0605 6536 The target volume cannot be changed
due to its LUSE configuration.
0605 6537 The setting process has not been
executed because there is no error in this
setting, but an error in the others settings.
0605 8000 An error occurred during SVP
processing.
0605 8001 An error occurred during SVP
processing.
0605 8102 This function is not supported.
0605 8122 Another maintenance processing is in
progress.
0605 8136 The command was rejected, because the
licensed capacity has exceeded the
maximum.
0605 8140 The configuration of Compatible
FlashCopy or Compatible FlashCopy SE
is defined.
Recommended Action
Release the definition of a reserved
volume, then retry the operation.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Install the necessary program product(s).
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Reduce the number of external volumes
registered in the storage system, then
retry the configuration operation.
Release the LUN Path, then change the
configuration again.
Release the LUSE volume, then change
the configuration again.
Check the error factor in the others
settings.
If this problem persists, please contact
HP Technical Support.
If this problem persists, please contact
HP Technical Support.
Check whether the DKCMAIN microcode
version and the SVP microcode version
are mismatched.
Wait for a while, then retry the
operation.
Check the licensed capacity, then specify
it within the licensed capacity or add the
licensed capacity.
Release the configuration definition of
Compatible FlashCopy, then retry the
operation.
Severity
Level
W
E
E
E
W
E
E
E
E
E
W
W
W
W
E
E
W
W
W
W
Part code 0605 49