HP XP P9500 Manual page 237

Hp p9000 remote web console messages (av400-96401, october 2011)
Hide thumbs Also See for XP P9500:
Table of Contents

Advertisement

Table 59 Error codes (part code 6610) (continued)
Part
Error
Error Message
Code
Number
6610
59009
Since the number of preview data
exceeded the maximum, the excess data
were discarded. No more preview data
can be stored.
6610
59010
WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
primary data volume and the secondary
data volume of the pair are already
synchronized?
6610
5901 1
Are you sure you want to output the %s
file?
6610
59013
The specified file already exists. Do you
want to overwrite this file?
6610
59026
The same DKC is specified more than
once. Check the DKC setting.
6610
59030
The monitoring data saved at present
will be deleted.
6610
59031
The monitoring data being saved at
present is deleted when the monitoring
switch is set to Enable at the next time.
6610
59040
You cannot add journal volumes because
Continuous Access Journal Z is not
installed.
6610
59041
Warning:
A mainframe volume is included in the
journal volumes to be deleted.
Note the following points if you have
made volume pairs by using this journal
before.
The mainframe volume will be
blocked.
The mainframe volume needs to be
formatted when you use the volume
as a non-journal volume.
The LDKC number, the CU number
and the LDEV number of the
mainframe volumes are recommended
to be recorded.
Do you want to continue the operation?
6610
59042
There are no valid journals.
Recommended Action
Click [OK]. Apply the preview data to
the storage system, then retry the
operation.
Check the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
To output the file, click [Yes]. Otherwise,
click [No].
To overwrite the file, click [Yes].
Otherwise, click [No].
Check the paramaters of the DKC setting.
To continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
To continue processing, click [OK]. To
stop processing, click [Cancel].
If the currently saved monitoring data is
needed, use the export tool to save the
data.
Purchase a license for Continuous Access
Journal Z, then install it.
To delete the journal volume, click [Yes].
Otherwise, click [No].
HP recommends that you record the
LDKC number, the CU number and the
LDEV number of the mainframe volume.
All journals are used by Continuous
Access Journal Z or Continuous Access
Journal. If possible, delete the journals
for Continuous Access Journal Z or
Severity
Level
W
i
i
W
W
W
i
W
W
W
Part code 6610 237

Advertisement

Table of Contents
loading

This manual is also suitable for:

P9000P9500

Table of Contents