HP XP P9500 Manual page 285

Hp p9000 remote web console messages (av400-96401, october 2011)
Hide thumbs Also See for XP P9500:
Table of Contents

Advertisement

Table 68 Error codes (part code 8105) (continued)
Part
Error
Error Message
Code
Number
8105
1067
You are trying to register the same host
group as the existing one.
8105
1068
The specified host group has not been
registered.
8105
1 108
The following volumes cannot be
specified when you change the
command device configurations:
Volumes reserved by Auto LUN
Volumes other than the open-system
volumes (including unmounted
volumes)
System Disk volume
8105
1 1 10
You cannot use following characters for
the name:
" \ / : , ; * ? < > |
You cannot use spaces for the first and
the last characters in the name.
8105
1 1 1 1
When requesting a configuration change
of LUN-Security, a nickname is not
specified. Specify the nickname of HOST
GROUP.
8105
1 1 16
When registering WWN, the value is
not specified. Or, zero is set as the value
of WWN. Be sure to set the WWN
value before requesting the configuration
change.
8105
1 123
Command device security cannot be set
to the specified volume because the
volume is not a command device.
8105
1 124
An error occurred. If this problem
persists, please contact HP Technical
Support.
The command device setting and the
command device security setting are
incorrect. You cannot do any of the
following to the same volume:
Specify the volume as a command
device and disable command device
security on the volume.
Specify the volume as a
non-command device and enable
command device security on the
volume.
8105
1 125
There are no host groups where the
WWN will be registered.
Recommended Action
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Check the setting, then retry the
operation.
Remove the prohibited characters from
the nickname.
Check the setting(s), then retry the
operation.
Check the setting(s), then retry the
operation.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The setting method of command
device/command device security is
incorrect. The following settings are
invalid. *Set command device + Release
command device security
*Release command device + Set
command device security
The error does not occur normally
because it cannot be modified in the
window. In the unlikely event that this
error occurs, please contact HP Technical
Support.
The configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
Severity
Level
W
W
W
W
W
W
W
W
W
Part code 8105 285

Advertisement

Table of Contents
loading

This manual is also suitable for:

P9000P9500

Table of Contents