HP XP P9500 Manual Page 154

Hp p9000 remote web console messages (av400-96401, october 2011).
Hide thumbs

Advertisement

Table 53 Error codes (part code 6005) (continued)
Part
Error
Code
Number
6005
8724
6005
8725
6005
8727
6005
8728
6005
8729
6005
8730
6005
8731
6005
8732
6005
8733
6005
8734
6005
8735
154 Message (part code group 6nnn)
Error Message
Specified number of paths is less than
the minimum specified on RCU Option
screen.
Current microcode version does not
support the specified operation.
The number of minimum paths exceeds
the number of normal paths.
The number of minimum paths exceeds
the number of normal paths.
An internal error occurred.
Invalid Logical Addresses are specified.
The existing logical addresses are not
equal.
Too many SSIDs (only Four SSIDs are
allowed).
The Fibre-Remote Copy function is not
installed in the specified MCU.
The Fibre-Remote Copy function is not
installed in the specified RCU.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
Recommended Action
The specified number of
paths is less than the
minimum number of paths
specified on the RCU Option
window.
The version of the microcode
on the 9900 storage system
does not support the
specified function or
operation. Please contact HP
Technical Support.
Add the normal path(s), then
set the minimum number of
paths.
Please take either of the
following actions:
Add normal paths, then
delete the paths.
Decrease the number of
minimum paths, then delete
the paths.
Please contact HP Technical
Support.
If you are adding RCUs,
specify the same logical
address.
If you are editing paths,
specify the same logical
address as the existing
paths. (See the Edit Path
dialog box.)
The logical addresses of all
existing paths are not the
same. Delete the RCU, then
re-add it, using the same
logical address as other
existing paths.
The maximum number of
SSIDs (four) has been
entered. Verify that the SSIDs
are valid, delete one or
more, then retry the
operation.
Install the program product
key in the MCU.
Install the program product
key in the RCU.
Check the serial number,
SSID and link address of the
RCU, and set the correct
value. Then retry the
operation. If the same error
Severity Level
W
W
W
W
E
W
W
W
W
W
W

Advertisement

   Also See for HP XP P9500

   Related Manuals for HP XP P9500

Comments to this Manuals

Symbols: 0
Latest comments: