HP XP P9500 Manual page 130

Table 48 Error codes (part code 5205) (continued)
Part Error
Code Number
5205 1209
5205 1210
5205 121 1
5205 1212
5205 1213
5205 1214
5205 1215
5205 1216
5205 1217
5205 1218
5205 1219
5205 1220
5205 1221
130 Message (part code group 5nnn)
Error Message
Auto LUN does not support the volume(s).
The shared memory to set a plan is
insufficient.
The number of volume pairs exceeds the
maximum.
The source volume(s) is not equipped.
The command was rejected due to one
of the following reasons.
The volume specified as a migration
source was blocked.
The volume specified as a migration
source was used as a system disk.
The volume specified as a migration
source is being formatted.
The volume specified as a migration
source is a command device.
The target volume(s) is not equipped.
The command was rejected due to one
of the following reasons.
The volume specified as a migration
target was blocked.
The volume specified as a migration
target was used as a system disk.
The volume specified as a migration
target is being formatted.
The volume specified as a migration
target is a command device.
The volume is not a reserved volume.
The volume(s) are already used by Auto
LUN.
Recommended Action
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Install the shared memory if it is possible.
If it is impossible to install the shared
memory, the plan cannot be set any
further.
See the section about the computational
methods of the number of movement
plans described in the HP P9000 Auto
LUN User Guide for the relation between
the number of plans that can be made
and the shared memory.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Recover the blocked volume, then retry
the operation. Also, the system disk
cannot be used as P-VOL. Specify
another volume.
Retry the operation after the format is
completed.
The command device cannot be used for
Auto LUN. Specify another volume.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Recover the blocked volume, then retry
the operation. Also, the system disk
cannot be used as P-VOL. Specify
another volume.
Retry the operation after the format is
completed.
The command device cannot be used for
Auto LUN. Specify another volume.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Retry the same operation. If nothing
changes, please contact HP Technical
Support.
Severity
Level
W
W
W
W
W
W
W
W
W
W
W
W
W