Monitoring Gre Tunnel Information; Table 35: Show Frame-Relay Subinterface Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

Meaning
Related
Documentation

Monitoring GRE Tunnel Information

Purpose
Copyright © 2010, Juniper Networks, Inc.
In errors: 0
In discards: 0
In unknown protos: 0
Frame relay policy output frOutputPolicy
classifier-group frGroupA entry 1
5 packets, 640 bytes
mark-de 1
Frame relay sub-interface SERIAL5/1:1/1.1, status is up
Number of sub-interface down transitions is 0
Time since last status change 03:05:09
No baseline has been set
In bytes: 660
In frames: 5
In errors: 0
In discards: 0
In unknown protos: 0
Frame relay policy input frInputPolicy
classifier-group frMatchDeSet entry 1
5 packets, 660 bytes
color red
Table 35 on page 181 lists the show frame-relay subinterface command output fields.

Table 35: show frame-relay subinterface Output Fields

Field Name
Frame Relay policy
mark-de
color
classifier-group
filter
forward
traffic class
user-packet-class
show frame-relay subinterface
Display information about GRE tunnels. The state keyword displays tunnels that are in
a specific state: disabled, down, enabled, not-present, or up. The ip keyword to display
tunnels associated with an IP address. To display information about a specific tunnel,
Chapter 9: Monitoring Policy Management
Out errors: 0
Out discards: 0
Out bytes: 660
Out frames: 5
Out errors: 0
Out discards: 0
Field Description
Type and name of the VLAN policy
DE bit value
Color applied to packet flow for queuing: green,
yellow, or red
Name of the classifier control list used by the
policy
Filter policy action
Forward policy action
Traffic class in the policy list
User packet class in the policy list
181