Monitoring Detailed Configuration Information For Specified Destinations - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 83: show l2tp Output Fields (continued)
Related Topics

Monitoring Detailed Configuration Information for Specified Destinations

Display detailed configuration information about specified destinations.
Purpose
To display detailed configuration information about specified destinations:
Action
To display information about a specific destination:
host1#show l2tp destination ip 172.31.1.98
L2TP destination 1 is Up with 5 active tunnels and 64 active sessions
To display information about all destinations:
host1#show l2tp destination detail 1
L2TP destination 1 is Up with 5 active tunnels and 64 active sessions
Configuration
Destination address
Destination status
Sub-interfaces total active failed auth-errors
Statistics
Field Name
Failover resync
Sub-interfaces
total
active
failed
auth-errors
show l2tp
Administrative state is enabled
SNMP traps are enabled
Transport ipUdp
Virtual router default
Local address 192.168.1.230, peer address 172.31.1.98
Effective administrative state is enabled
Tunnels 5 5
Sessions 64 64
packets
Control rx 69
Control tx 195
Monitoring Detailed Configuration Information for Specified Destinations
Chapter 16: Monitoring L2TP and L2TP Dial-Out
Field Description
Global L2TP peer resynchronization configuration
Sub-interface information about L2TP
Number of destinations, tunnels, and sessions that
the router created
Number of operational destinations, tunnels, and
sessions
Number of requests that did not reach an operational
state
Number of requests that failed because the tunnel
password was invalid
0 0
0 n/a
octets discards errors
3251 2
23939 0
0
0
429