Chapter 1
Configuring Remote Access
This chapter describes how to configure remote access to an Juniper Networks E
Series Broadband Services Router. This chapter discusses the following topics:
Remote Access Overview on page 4
Remote Access Platform Considerations on page 5
Remote Access References on page 6
Before You Configure B-RAS on page 6
Remote Access Configuration Tasks on page 6
Configuring a B-RAS License on page 7
Mapping a User Domain Name to a Virtual Router on page 8
Setting Up Domain Name and Realm Name Usage on page 12
Specifying a Single Name for Users from a Domain on page 16
Configuring RADIUS Authentication and Accounting Servers on page 18
Configuring Local Authentication Servers on page 40
Configuring Tunnel Subscriber Authentication on page 50
Configuring Name Server Addresses on page 51
Configuring Local Address Servers on page 54
Configuring DHCP Features on page 60
Creating an IP Interface on page 61
Configuring AAA Profiles on page 63
Using RADIUS Route-Download Server to Distribute Routes on page 71
Using the AAA Logical Line Identifier to Track Subscribers on page 76
Using VSAs for Dynamic IP Interfaces on page 82
Mapping Application Terminate Reasons to RADIUS Terminate Codes on page 84
Configuring Timeout on page 88
Limiting Active Subscribers on page 89
Notifying RADIUS of AAA Failure on page 90
Configuring Standard RADIUS IPv6 Attributes for IPv6 Neighbor Discovery Router
Advertisements and DHCPv6 Prefix Delegation on page 90
Propagation of LAG Subscriber Information to AAA and RADIUS on page 92
3