Configuring Remote Access - Juniper JUNOSE SOFTWARE 11.2.X - BROADBAND ACCESS CONFIGURATION GUIDE 7-20-2010 Configuration Manual

CHAPTER 1

Configuring Remote Access

Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to configure remote access to an Juniper Networks E Series
Broadband Services Router. This chapter discusses the following topics:
Remote Access Overview on page 4
Remote Access Platform Considerations on page 5
Remote Access References on page 6
Before You Configure B-RAS on page 6
Remote Access Configuration Tasks on page 6
Configuring a B-RAS License on page 7
Mapping a User Domain Name to a Virtual Router on page 8
Setting Up Domain Name and Realm Name Usage on page 11
Specifying a Single Name for Users from a Domain on page 16
Configuring RADIUS Authentication and Accounting Servers on page 17
Configuring Local Authentication Servers on page 38
Configuring Tunnel Subscriber Authentication on page 48
Configuring Name Server Addresses on page 49
Configuring Local Address Servers on page 51
Configuring DHCP Features on page 58
Creating an IP Interface on page 58
Configuring AAA Profiles on page 60
Using RADIUS Route-Download Server to Distribute Routes on page 68
Using the AAA Logical Line Identifier to Track Subscribers on page 73
Using VSAs for Dynamic IP Interfaces on page 78
Mapping Application Terminate Reasons to RADIUS Terminate Codes on page 81
Configuring Timeout on page 84
Limiting Active Subscribers on page 86
Notifying RADIUS of AAA Failure on page 86
Configuring Standard RADIUS IPv6 Attributes for IPv6 Neighbor Discovery Router
Advertisements and DHCPv6 Prefix Delegation on page 87
3