Monitoring Ignored Radius Attributes; Setting The Baseline For Radius Dynamic-Request Server Statistics - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide
Table 58: show radius attributes-included Output Fields (continued)
Related Topics

Monitoring Ignored RADIUS Attributes

Display the RADIUS attributes that are ignored in Access-Accept messages.
Purpose
To display the RADIUS attributes that are ignored:
Action
host1#show radius attributes-ignored
attribute framed-ip-netmask ignored from RADIUS server
attribute atm-service-category (vsa) accepted from RADIUS server
attribute atm-mbs (vsa) accepted from RADIUS server
attribute atm-pcr (vsa) accepted from RADIUS server
attribute atm-scr (vsa) accepted from RADIUS server
attribute egress-policy-name (vsa) accepted from RADIUS server
attribute ingress-policy-name (vsa) accepted from RADIUS server
attribute virtual-router (vsa) accepted from RADIUS server
attribute pppoe-max-session (vsa) ignored from RADIUS server
Related Topics

Setting the Baseline for RADIUS Dynamic-Request Server Statistics

You can set a statistics baseline for packet mirroring-related RADIUS statistics. To
show baseline statistics, use the delta keyword with the show radius
dynamic-request statistics command.
To set a baseline for RADIUS statistics for packet mirroring:
304
Monitoring Ignored RADIUS Attributes
Field Name
Account Off
Access Request
Account Start
Account Stop
show radius attributes-included
show radius attributes-ignored
Issue the baseline radius dynamic-request command:
host1#baseline radius dynamic-request
Field Description
Include status of the attribute in Acct-Off messages:
enabled, disabled, n/c
Include status of the attribute in Access Request
messages: enabled, disabled, n/c
Include status of the attribute in Acct-Start messages:
enabled, disabled, n/c
Include status of the attribute in Acct-Stop messages:
enabled, disabled, n/c