Monitoring Application Terminate Reason Mappings - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
Table 32: show subscribers Output Fields (continued)
Related Topics

Monitoring Application Terminate Reason Mappings

Display information about the mappings for application terminate reasons.
Purpose
To display the current terminate reasons that are mapped to a specific
Action
Acct-Terminate-Cause-Code:
This example uses the radius keyword to display all current terminate reasons
mapped to RADIUS Acct-Terminate-Cause codes. The output lists all PPP mappings,
followed by L2TP mappings, and then AAA mappings.
host1(config)#run show terminate-code radius
---------
ppp
ppp
162
Monitoring Application Terminate Reason Mappings
Field Name
Peak Subscribers
Subscribers
Ppp
Ip
Tnl
Total
Domain Name
ICR-Partition (location-id)
Count
Slot
show subscribers
Apps Terminate Reason
--------------------------
authenticate-authenticator
-timeout
authenticate-challenge-tim
Field Description
Maximum value of the Total Subscriber field during
the time the router has been active, chassis-wide
Number of subscribers; the sum of the Ppp and Ip
fields
Number of PPPoA and PPPoE users, combined
Number of DHCP and IP subscriber manager users,
combined
Number of users tunneled to an LNS
Total number of users per virtual router; the sum of
the Ppp, Ip, and Tnl fields
Domain name used by the subscriber
A unique identifier for each ICR partition on a chassis.
Note that this ID different from the partition name,
which is configured using the ip vrrp vrid
icr-partitionpartitionName command.
Number of subscribers
Number of slot in the chassis
Description
--------------------------
authenticate authenticator
timeout
authenticate challenge tim
Radius
Code
------
17
10