Table of Contents
Advertisement
JunosE 11.3.x Physical Layer Configuration Guide
Configuration Tasks
Configuring a T3 Controller
controller t3
shutdown
10
Framing type, clock source, cable length, and the loopback method for each T3
controller
Framing type and clock source for each T1 channel
Timeslot mapping and line speed for each fractional T1 channel
HDLC channel information, such as data inversion information, cyclic redundancy check
(CRC) type, idle character, maximum transmission unit (MTU), and maximum receive
unit (MRU)
To configure a channelized T3 interface:
Configure a T3 controller.
1.
(Optional) Configure MDL settings.
2.
(Optional) Configure other settings for the interface.
3.
Configure T1 channels and subchannels.
4.
Configure HDLC channels.
5.
To configure a T3 controller:
Access Controller Configuration mode by specifying the T3 controller.
1.
host1(config)#controller t3 0/1
Enable the T3 controller.
2.
T3 controllers are disabled by default.
host1(config-controll)#no shutdown
Use to specify a T3 controller in slot/port format.
slot—Number of the slot in which the line module resides in the chassis
port—Number of the port on the I/O module
Example
host1(config)#controller t3 0/1
There is no no version.
See controller t3.
Use to disable a T3 controller.
The T3 interface is disabled by default.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
