Remote Access References; Before You Configure B-Ras; Remote Access Configuration Tasks - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Broadband Access Configuration Guide

Remote Access References

For more information about the topics covered in this chapter, see the following
documents:
JUNOSe Release Notes, Appendix A, System Maximums Refer to the Release Notes
corresponding to your software release for information about the number of
concurrent RADIUS requests that the router supports for authentication and accounting
servers.

Before You Configure B-RAS

Before you begin to configure B-RAS, you need to collect the following information
for the RADIUS authentication and accounting servers:

Remote Access Configuration Tasks

Each configuration task is presented in a separate section in this chapter. Most of
the B-RAS configuration tasks are optional.
To configure B-RAS, perform the following tasks:
1.
2.
3.
4.
6
Remote Access References
Bridged Ethernet
Layer 2 Tunneling Protocol (L2TP), both L2TP access concentrator (LAC) and
L2TP network server (LNS)
RFC 2748 The COPS (Common Open Policy Service) Protocol (January 2000)
RFC 2865 Remote Authentication Dial In User Service (RADIUS) (June 2000)
RFC 3084 COPS Usage for Policy Provisioning (COPS-PR) (March 2001)
RFC 3159 Structure of Policy Provisioning Information (SPPI) (August 2001)
RFC 3198 Terminology for Policy-Based Management (November 2001)
RFC 3317 Differentiated Services Quality of Service Policy Information Base
(DIFFSERV-PIB)
RFC 3318 Framework Policy Information Base (March 2003)
IP addresses
User Datagram Protocol (UDP) port numbers
Secret keys
Configure a B-RAS license.
(Optional) Map a user domain name to a virtual router. By default, all requests
go through a default router.
(Optional) Set up domain name and realm name usage.
(Optional) Specify a single name for users from a domain.