Table 115: Chassis Viewer For Ex4500 Switches - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 114: Chassis Viewer for EX3200 and EX4200 Switches (continued)
Field
USB port
Management ( me0 ) port
Console port
Power supplies

Table 115: Chassis Viewer for EX4500 Switches

Field
Front View
Interface status
LCD panel
Console port
Management ( ) port
me0
USB port
Rear View of the EX4500 Switch
Copyright © 2010, Juniper Networks, Inc.
Description
Indicates the USB port for the switch.
NOTE: We recommend you use USB flash drives purchased from Juniper Networks for your EX
Series switch.
The management port is used to connect the switch to a management device for out-of-band
management.
The console port is used to connect the switch to a management console or to a console server.
(You might do this for initial switch configuration.)
Hover the mouse pointer over the power supply icons to display Name, Status, and Description
information.
Description
In the image, the colors listed below denote the interface status:
Green—Interface is up and operational.
Yellow—Interface is up but is nonoperational.
Gray—Interface is down and nonoperational.
Hover the mouse pointer over the interface (port) to view more information.
If an SFP+ uplink module is installed in the switch, hover the mouser pointer over the interface
(ports) on the module for more information.
For SFP and SFP+ ports, the interfaces appear dimmed if no transceiver is inserted. The chassis
viewer displays "Transceiver not plugged-in" when you hover the mouse pointer over the port
icon.
The two M1 modules provide uplink capabilities to the device.
LCD panel configured for the LEDs on the ports. Hover the mouse pointer over the icon to view
the current character display.
The console port is used to connect the switch to a management console or to a console server.
The management port is used to connect the switch to a management device for out-of-band
management. Use this port for initial switch configuration.
Indicates the USB port for the switch.
NOTE: We recommend you use USB flash drives purchased from Juniper Networks for your EX
Series switch.
Chapter 33: System Monitoring Overview
635