Telnet - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

telnet

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
telnet host
<8bit>
<bypass-routing>
<inet | inet6>
<interface interface-name>
<logical-system logical-system-name>
<no-resolve>
<port port-number>
<routing-instance routing-instance-name>
<source source-address>
telnet host
<8bit>
<bypass-routing>
<inet | inet6>
<interface interface-name>
<no-resolve>
<port port-number>
<routing-instance routing-instance-name>
<source source-address>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Open a telnet session to a remote system. Type Ctrl+] to escape from the telnet session
to the telnet command level, and then type
—Name or address of the remote system.
host
—(Optional) Use an 8-bit data path.
8bit
—(Optional) Bypass the normal routing tables and send ping requests
bypass-routing
directly to a system on an attached network. If the system is not on a directly attached
network, an error is returned. Use this option to ping a local system through an
interface that has no route through it.
—(Optional) Open an IPv4 or IPv6 session, respectively.
inet | inet6
interface interface-name —(Optional) Interface name for the telnet session. (This option
does not work when
default-address-selection
hierarchy level, because this configuration uses the loopback interface as the source
address for all locally generated IP packets.)
logical-system logical-system-name
the telnet attempt.
—(Optional) Do not attempt to determine the hostname that corresponds to
no-resolve
the IP address.
port port-number —(Optional) Port number or service name on the remote system.
Chapter 32: Operational Commands for System Services
to exit from telnet.
quit
is configured at the
—(Optional) Name of a particular logical system for
[edit system]
625