Table of Contents
Advertisement
Add a Member to a Virtual Chassis
150
Power on only the switch that you plan to use as the master switch (SWA-0). Do not
4.
power on the other switches at this time.
Run the EZ Setup program on SWA-0, specifying the identification parameters. See
5.
Connecting and Configuring an EX Series Switch (CLI Procedure) for details.
NOTE: The properties that you specify for SWA-0 apply to the entire virtual
chassis, including all the member listed in the preprovisioned configuration
file.
Specify all the members that you want to included in the virtual chassis, listing each
6.
switch's serial number with the desired member ID and the desired role:
Power on the member switches.
7.
NOTE: You cannot modify the mastership-priority when you are using a
preprovisioned configuration. The mastership priority values are generated
automatically and controlled by the role that is assigned to the member
switch in the configuration file. The two routing engines are assigned the
same mastership priority value. However, the member that was powered on
first has higher prioritization according to the master election algorithm. See
Understanding How the Master in an EX4200 Virtual Chassis Is Elected.
To add a member switch to a virtual chassis:
In the navigation tree, select Device Manager > Devices. In Device Manager, select the
1.
device for which you want to add a member switch.
In the Configuration tree, expand Virtual Chassis.
2.
Select Member.
3.
Add/modify member settings for the interface as specified in Table 85 on page 147.
4.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
