No Debug All - Allied Telesis x510-28GTX Command Reference Manual

S C M
YSTEM ONFIGURATION AND

NO DEBUG ALL

no debug all
Overview This command disables the debugging facility for all features on your device. This
stops the device from generating any diagnostic debugging messages.
The debugging facility is disabled by default.
Syntax no debug all [ipv6|dot1x|nsm|ospf|pim dense-mode|pim
sparse-mode|rip|vrrp]
Mode Global Configuration and Privileged Exec
Example To disable debugging for all features, use the command:
awplus#
To disable all 802.1X debugging, use the command:
awplus#
To disable all IPv6 debugging, use the command:
awplus#
To disable all NSM debugging, use the command:
awplus#
To disable all OSPF debugging, use the command:
awplus#
To disable all PIM Dense Mode debugging, use the command:
awplus#
C613-50170-01 Rev B
C
ONITORING OMMANDS
Parameter
dot1x
ipv6
nsm
ospf
pim dense-mode
pim sparse-mode
rip
vrrp
no debug all
no debug all dot1x
no debug all ipv6
no debug all nsm
no debug all ospf
no debug all pim dense-mode
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Turns off all debugging for IEEE 802.1X port-based network
access- control.
Turns off all debugging for IPv6 (Internet Protocol version 6).
Turns off all debugging for the NSM (Network Services
Module).
Turns off all debugging for OSPF (Open Shortest Path First).
Turns off all debugging for PIM (Protocol Independent
Multicast) Dense Mode.
Turns off all debugging for PIM (Protocol Independent
Multicast) Sparse Mode.
Turns off all debugging for RIP (Routing Information Protocol).
Turns off all debugging for VRRP (Virtual Router Redundancy
Protocol).
253