Drawbar Hitch Dh-2V (Short Towing Yoke) - Belarus 2022.6 Operator's Manual

4.4.2 Drawbar hitch DH-2V (short towing yoke)

Figure 4.4.1 – Installation variant diagram of DH-2V (short towing yoke)
Table 4.4.1 – Basic parameters and coupling dimensions of DH-2V (short towing yoke)
Standard size (configuration) of the device
1. Variant
2. Mounting location
3. Design features
4. Assignment
5. DH yoke dimensions, mm:
а) connecting pin diameter
b) yoke gap height
c) yoke gap depth
1
d) yoke position for the implements driven by rear
PTO shaft
e) distance between the PTO butt end and the
connecting pin axis, mm
6. Trailing device for coupling to DH:
а) type
b) vertical load in hitch point, kN, not more than
c) turning angle of the implement trailing device in
horizontal plane, degrees, not less than
d) protective device type
e) connection point of the protective device on the
tractor
7. Relative calculated value of axial forces, kN, not
more than
_________________________________________________________________________________________________
1)
Recommended.
2)
Implement accessories.
ATTENTION: IT IS FORBIDDEN TO PUT DH-2V YOKE TO A POSITION WHERE
ITS BODY OVERHANGS THE DH SUPPORTING BRACKET END (UP OR DOWN) FOR
MORE THAN 15 ММ!
DH-2V (short towing yoke)
Yoke acc. to ISO Yoke acc. to GOST
Rear lifting device
Non-rotational, height adjustable
For connection and coupling of trailed,
semi-trailed implements with traveling
wheels, including tractor semi-trailer
type
Lower position, as shown in figure
4.4.1
110
Rigid, with tractor drawbar clevis
Safety chain (rope)
Lifting device holes
111
2022.6-0000010 OM
40
85
70
160
20
±60
2)
70.1